Section 119311 Of Article 3. Practitioner Registration From California Health And Safety Code >> Division 104. >> Part 15. >> Chapter 7. >> Article 3.
119311
. (a) A product applied to the skin prior to tattooing or
application of permanent cosmetics, including, but not limited to,
stencils and marking and transfer agents, including pens, shall be
single use and discarded into a waste container at the end of the
procedure unless the product can be disinfected for reuse.
(b) Only commercially manufactured inks, dyes, and pigments shall
be used.
(c) Inks, pigments, soaps, and other products in multiple-use
containers shall be dispensed in a manner to prevent contamination of
the storage container and its remaining contents through the use of
a single-use receptacle.
(d) Inks and pigments shall be placed into a clean, single-use
receptacle. The inks and pigments remaining in the receptacle shall
be discarded immediately upon completion of the procedure.
(e) If a tray is used for inks or pigments, it shall be
decontaminated after each procedure.
(f) Only single-use needles and needle bars shall be used in
tattooing and the application of permanent cosmetics. Needles and
needle bars that are purchased in a nonsterilized state, shall be
sterilized, pursuant to the process required by Section 119315.
(g) Needles, needle bars, grommets, and razors shall be discarded
into a sharps waste container immediately upon completion of the
procedure.
(h) Any part of a tattooing machine that may be touched by the
practitioner during the procedure shall be covered with a disposable
plastic sheath that is discarded upon completion of the procedure,
and the machine shall be decontaminated upon completion of the
procedure.
(i) A machine used to insert pigments shall be designed with
removable tip parts between the tip and motor housing, and in a
manner that will prevent backflow into enclosed parts of the motor
housing.
(j) A hand tool used to insert pigment shall be disposed of in a
sharps container, with the sharps intact, unless the needle can be
mechanically ejected from the hand tool.